# Coolant System Pressure and Vacuum Valve Repair in Upland > Hoses collapsed after cool-down or coolant stuck in the reservoir? Route 66 Auto Repair in Upland repairs the vacuum return valve side of the cooling system. Source: https://route66autorepairshop.com/cooling-heating-ac-services/coolant-system-pressure-valve-repair Updated: 2026-09-17 Business: Route 66 Auto Repair, 1775 W Foothill Blvd, Upland, CA 91786, (909) 608-7699 Hours: Monday to Friday 8 AM–5 PM, Saturday 8 AM–2 PM, Sunday closed **TLDR:** A **collapsed hose** after cool-down points to a stuck **vacuum valve**. We check both sides of the cap and the return path before replacing parts. Every pressure cap has two valves: one lets pressure out when hot, and a smaller vacuum valve lets coolant back in as the engine cools. When that vacuum side sticks, hoses collapse overnight and coolant stays stranded in the reservoir. Route 66 Auto Repair in Upland diagnoses both valves and the lines they depend on, then repairs the part that is blocking return flow. ## What are the signs of a stuck vacuum valve? - Upper hose flattened in the morning - Reservoir overfull while the radiator runs low - A whoosh of air when you open a cold cap - Heater output fading over a few days - Temperature rising after several drives with no visible leak ## How does the vacuum return side work? As coolant cools, it shrinks and creates a slight vacuum. The small valve in the center of the cap opens and lets coolant flow back from the reservoir. If that valve is stuck from corrosion or debris, the vacuum pulls on the hoses instead, and they can flatten. Over time, the radiator loses coolant to the reservoir and never gets it back. The return path matters too. A kinked or cracked overflow line gives similar symptoms, which is covered on [radiator overflow hose repair](https://route66autorepairshop.com/cooling-heating-ac-services/radiator-overflow-hose-repair). The high-pressure side of the cap is tested on [cooling system radiator cap test](https://route66autorepairshop.com/cooling-heating-ac-services/cooling-system-radiator-cap-test). ## Our pressure valve repair process 1. **Observe cold:** We check the hoses and reservoir level before the engine is started. 2. **Test both valves:** The cap's pressure and vacuum valves are checked for release and free movement. 3. **Check the return path:** The overflow line and reservoir outlet are checked for kinks, cracks or clogs. 4. **Repair and cycle:** The failed part is replaced, the level is corrected, and a full hot-to-cold cycle confirms coolant returns. ## What's included in pressure valve repair - Cold hose and reservoir inspection - Pressure and vacuum valve test - Overflow line and reservoir outlet check - Replacement cap, valve or line as quoted - Hot-to-cold cycle verification ## Can a stuck valve wait? **Need now:** - Radiator low with rising temperature - Hoses collapsing enough to restrict flow - Heat loss from a low radiator **Need later:** - Slight hose softness in the morning with normal levels - Cap seal starting to harden but valves working ## How pricing and timing work The usual fix is a cap or a small line, which is a modest cost. Testing takes time because we watch a full heat cycle. The diagnostic fee is stated at the counter before testing and applies to approved related repair. You get a written estimate first, and most of these are done in one visit when the board allows. ## After the repair Check the hoses and reservoir cold for a few mornings. Hoses should feel round and the level should be steady. If coolant loss continues, a [coolant system leak detection](https://route66autorepairshop.com/cooling-heating-ac-services/coolant-system-leak-detection) visit is the next step. Call [(909) 608-7699](tel:+19096087699) with questions. ## Frequently asked questions ### Is a collapsed hose dangerous? A lightly flattened hose that pops back when warm is a warning sign. A hose that stays collapsed can restrict flow and cause overheating. ### Can I clean the valve on my cap? Sometimes debris can be rinsed off, but a corroded or weak valve will stick again. A tested new cap is the reliable fix. ### Why is my reservoir full when the radiator is low? Coolant is going out to the reservoir but not coming back. A stuck vacuum valve or a blocked return line is the usual cause. --- Call (909) 608-7699 or visit https://route66autorepairshop.com/contact for a written estimate.