# Starter Motor Condition Inspection in Upland > Click but no crank? Our Upland starter motor inspection tests cranking voltage, current draw and cables so you replace the starter only when it is the cause. Source: https://route66autorepairshop.com/diagnostics-and-inspections/starter-motor-condition-inspection Updated: 2026-09-17 Business: Route 66 Auto Repair, 1775 W Foothill Blvd, Upland, CA 91786, (909) 608-7699 Hours: Monday to Friday 8 AM–5 PM, Saturday 8 AM–2 PM, Sunday closed **TLDR:** We measure **cranking voltage and current draw**, test the **relay and cables**, and replace the starter only when it is the cause. A starter motor condition inspection at Route 66 Auto Repair in Upland finds out why your engine clicks, cranks slowly or does nothing at all. The starter is often blamed, but cables, grounds, relays and the battery cause many of the same symptoms. We measure voltage and current while cranking, test the control circuit and write down exactly which part failed. ## Signs of a starter problem - A single click and no crank - Slow, labored cranking, worse when the engine is hot - A grinding noise during or after starting - The starter keeps spinning after the engine is running - Tapping the starter makes it work for a while ## How do we test a starter? We start with the battery, because a weak battery makes every starter look bad. Then we crank the engine while reading voltage at the starter's main terminal. If the battery shows good voltage but the starter terminal shows much less, the loss is in the cables or connections, not the starter. We check the ground path the same way. An inductive clamp measures current draw during cranking. High draw with slow cranking suggests a dragging starter or a mechanical engine problem. Low draw with no cranking points to the solenoid or the control circuit. We test the start signal at the solenoid, the relay and the neutral safety or clutch switch. Heat soak is a common Inland Empire issue: a starter near the exhaust may fail only when hot, so we test hot when that is the complaint. ## What the starter report records - Battery state before testing - Voltage at the starter during cranking - Cable and ground voltage drop - Current draw during cranking - Start signal, relay and switch results - Grinding or gear damage, with photos if the starter is removed ## Our starter inspection steps 1. **Battery check:** We confirm the battery can support a fair test. 2. **Crank test:** Voltage and current are measured while cranking. 3. **Control circuit:** Relay, switch and start signal are tested. 4. **Report:** You get the failed part, the proof and the estimate. ## What's included in a starter motor condition inspection - Battery state-of-charge check - Cranking voltage at the starter - Current draw measurement - Cable and ground voltage drop test - Relay and start signal test - Written findings ## Need-now or need-later? **Need now:** - A no-start caused by the starter or its circuit - A starter that stays engaged after the engine runs - Grinding that can damage the flywheel teeth **Need later:** - Slightly slow cranking only on the hottest days - A corroded cable end with passing voltage drop ## How pricing and timing work The inspection fee is stated at the counter first. Starter access varies widely: some are easy to reach, and others sit under the intake. The written estimate shows the labor for your vehicle. If your car will not start, we accept tow-ins and have an after-hours key drop. AAA members save 10% on parts and labor, up to $75. ## What to read next A failed starter leads to [starter motor repair](https://route66autorepairshop.com/electrical-services/starter-motor-repair). Solenoid faults are covered under [starter solenoid repair](https://route66autorepairshop.com/electrical-services/starter-solenoid-repair), and relay faults under [starter relay replacement](https://route66autorepairshop.com/electrical-services/starter-relay-replacement). If the loss was in the cables, see the [battery terminal inspection](https://route66autorepairshop.com/diagnostics-and-inspections/battery-terminal-inspection). ## Frequently asked questions ### Can you replace my starter if it is only clicking? Yes, once we confirm the starter is the cause. A click is often a battery or cable problem, so we test first and put the result in writing. ### Why does tapping the starter work? Worn contacts inside the starter or solenoid can stick. A tap can free them for a while, but it is a sign the starter is near the end of its life. ### Why does my car crank slowly only when hot? Heat increases electrical resistance, and starters near the exhaust get very hot. A borderline starter or cable shows up then. We test hot when that is the complaint. --- Call (909) 608-7699 or visit https://route66autorepairshop.com/contact for a written estimate.