# Oil Pump Gasket Repair in Upland > Oil pump gasket repair in Upland for outside leaks and air-sucking pickup seals that drop pressure. Route 66 Auto Repair tests before it quotes. Source: https://route66autorepairshop.com/oil-change-services/oil-pump-gasket-repair Updated: 2026-09-17 Business: Route 66 Auto Repair, 1775 W Foothill Blvd, Upland, CA 91786, (909) 608-7699 Hours: Monday to Friday 8 AM–5 PM, Saturday 8 AM–2 PM, Sunday closed **TLDR:** Outside gasket leaks drip oil; a failed **pickup seal** pulls in air and **drops pressure**. We tell the two apart before quoting. An oil pump gasket can fail in two ways, and Route 66 Auto Repair in Upland checks for both. A pump body or front cover gasket that leaks outward drips oil at the front of the engine. A pickup tube gasket or O-ring that leaks inward lets the pump pull in air, which shows up as low or unsteady oil pressure with no visible leak at all. We test first, then reseal what failed. ## Leaking out or leaking in: what is the difference? The pump body or front cover bolts to the block with a gasket or sealant. When that seal fails, oil pushes out and runs down the front of the engine. It is messy, but pressure usually stays normal until the level drops. Inside the pan, the pickup tube carries oil from the bottom of the sump to the pump inlet, sealed by a small gasket or O-ring. If that seal hardens, cracks or was pinched during an earlier pan job, the pump draws air along with oil. Aerated oil does not hold pressure well, so the light may flicker at hot idle or during hard cornering and braking. ## Which clues do we look for? - Fresh oil at the pump body or front cover seam - Pressure that wanders on a mechanical gauge at hot idle - Foamy oil on the dipstick - A pickup O-ring that is flat or cracked once the pan is off - A recent pan gasket job followed by a pressure warning ## Why do pump gaskets fail? Age and heat harden rubber. Old cork and paper gaskets shrink. On the pickup side, reusing the old O-ring during a pan repair is a frequent cause, as is a pickup bracket bolt left loose. Inland Empire heat speeds things up; engines that run hot in summer traffic age their seals sooner. A leak at the crank snout instead is covered on [oil pump seal replacement](https://route66autorepairshop.com/oil-change-services/oil-pump-seal-replacement). ## How we repair a pump gasket 1. **Clean and test:** Degrease for outside leaks, and run a mechanical pressure test for suspected air leaks. 2. **Locate the seal:** We confirm whether the pump body, front cover or pickup seal is at fault. 3. **Estimate the access:** You get a written estimate showing what must come off to reach that seal. 4. **Reseal:** Surfaces are cleaned, and new gaskets or O-rings go in with bolts torqued to spec. 5. **Prime and verify:** The system is primed, pressure is read again with the gauge, and we road-test. ## What's included in pump gasket repair - Outside leak cleaning and inspection - Mechanical pressure test for suspected air leaks - New pump body, front cover or pickup seals as needed - Pickup tube bracket and bolt check - Fresh oil and filter after the repair - Pressure and leak verification ## Which pump gasket problems are urgent? **Need now:** - A flickering oil light with a pressure drop on the gauge - Foamy oil together with low pressure **Need later:** - A slow outside seep at the pump seam with steady pressure - A seal to renew the next time the pan or front cover is off ## How pricing works A pickup seal means removing the oil pan, so the price follows the pan labor for your engine. A front cover gasket can mean removing the timing drive. We write out the access steps so the price makes sense before you approve. AAA members get 10% off parts and labor, up to $75, with the card at the time of service. Full pump diagnosis is on our [oil pump repair](https://route66autorepairshop.com/oil-change-services/oil-pump-repair) page, and if the pan comes off, [oil pan gasket replacement](https://route66autorepairshop.com/oil-change-services/oil-pan-gasket-replacement) explains that part. ## Frequently asked questions ### Can a bad gasket really cause low oil pressure? Yes, when it is on the suction side. A leaking pickup seal lets air in, and the pump cannot build full pressure with foamy oil. It is one of our checks before blaming the pump. ### Why did my oil light start flickering after a pan repair? The pickup O-ring may have been reused or pinched. Take it back to whoever did the work. If that was us, it goes to the front of the line and the cause is written on the repair order. ### Is sealant better than a gasket here? Use what the engine maker specifies. Some front covers use formed-in-place sealant; pickup tubes use a specific O-ring or gasket. Extra sealant near a pickup can break loose and block the screen. --- Call (909) 608-7699 or visit https://route66autorepairshop.com/contact for a written estimate.